Display the Peer Information

Use the following procedure to display the peer configuration and SA message information.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Display the peer information:

    show ip msdp peer {A.B.C.D} [vrf WORD<0-16>] [vrfids WORD<0-512>]

Example

Switch:#enable
Switch:1#show ip msdp peer 2.2.2.2
============================================================================
                          MSDP Peer - GlobalRouter
 ============================================================================
MSDP Peer 2.2.2.2, AS 109Admin Status: Enabled
Operational Status: Enabled
Description:
Connection status:
FSM State: Established, Establish Count: 9,
Connection source: 2.2.2.17
Uptime (Downtime): 1d10h, Messages sent/received:
436765/429062
Connection and counters cleared 1w2d ago
SA Filtering:
Input (S,G) route-policy: none
Output (S,G) route-policy: none
SA In count: SA out Count:
SA-Requests:
Input filter: none
Sending SA-Requests to peer: disabled
SA Request In Count: SA Request out Count:
SA Response In Count: SA Response out Count:
Peer ttl threshold: 0
SAs learned from this peer: 32, SAs limit: 500
Peer RPF failure Count:
KeepAlive In Count:
KeepAlive out count:
Encapsulated Data packets In:
Encapsulated Data Packets out:
KeepAlive Timer:
Peer Hold timer:
Connection Retry timer:
Encapsulation type:
MD5 Authentication: Enabled, MD5 Password:
%d462277d77
Peer FSM Established Time:
Peer In Message Time:
Remote port: Local port:
Number of connection Attempts:
Discontinuity timeout:
Too Short MSDP message Rx count:
Bad MSDP message Rx count:

Variable definitions

The following table defines parameters for the show ip msdp peer command.

Variable

Value

{A.B.C.D}

Specifies the MSDP peer IP address.

vrf WORD<0–16>

Displays configuration info for a particular VRF.

vrfids WORD<0–512>

Displays configuration info for a particular VRF ID.